How to Sublimate License Plate: Step by Step Guide for Beginners

Are you a car darling and cherish customizing your car with unused and alluring highlights? How about having your own customized and trendsetting fancy license plate. Then why not apply sublimation to your conventional boring license plate. 

Yeah, you heard it right! Sublimation printing is the technique that gives you the leverage of making your own customized crafts including your car’s license plate as well. In this article, you will learn how to sublimate license plate with your very own custom designs without investing a parcel of your capital and time. 

So without further ado, let’s dig in!

License plate sublimation: A Basic Guide to the Procedure

Sublimation on license plate requires certain types of equipment:

If you’re as of now in sublimation printing, you are most likely to have all of the materials at home that we have recorded underneath.

  • Aluminum License Plates 
  • Sublimation printer 
  • Sublimation ink 
  • Heat Press machine  
  • Sublimation paper
  • Temperature Resistant Gloves 
  • Lint Roller 
  • Temperature Resistant Tape 
  • Silicon Protective Paper
  • Nomex (a lightweight, fire-resistant fiber) Pad 
  • Silicon mat (parchment paper)

THE STEP BY STEP PROCESS TO SUBLIMATE LICENSE PLATE

Step 1

The permit plate spaces are around 5.88″ / 11.88″, so it’ll not work on an 8.5″ * 11″ sheet of transfer paper. You will need the 8.5″ x 14″ sublimation sheet. Select the design of your choice. Print your design using a wide format sublimation printer.

Step 2:

The license plate’s sealer needs to be removed. Simply begin with one corner and work your way back. This preserves the license plate’s finish while removing the seal. Using a lint roller, go over through the entire top of the license plate to clean it thoroughly.

Step 3:

Place your sublimation print on the table with the ink side up, and place the license plate on top of the print with the sublimated cut side. Make sure your full license plate is coated with your design to ensure proper placement. Adhere the license plate to your paper using tape. To keep it stable while sublimating, We often use heat-resistant tapes in 4 locations.

Place a Nomex pad, as well as sublimation, felt on the underside of the heat press, therefore a layer of protection paper, then the permit plate. You’ll want to turn it over so the sublimation design is on top. Add a layer of protection papers on top of that.

Step 4:

Adjust your heat press to 385°F with moderate pressure for 2 minutes.  After it has been heated, cycle the heat press up or down for just a few moments to warm up the foundation before inserting the license plate. You need to make it absolutely sure that your sublimation design is placed on top, and then press for the above mentioned time temperature and pressure. Remove the plate from the flame while wearing heat-resistant gloves. Retrieve the sublimation printing & put it on a hot griddle surface to display your beautiful design.

Conclusion:

We honestly hope that after reading this article, you’ll be able to custom-sublimate your permit plate. If you have any additional questions or would want to share, a suggestion, please do so in the comments section below. Thank you for reading this article.

Leave a Reply